800.876.4857
[email protected]

Categories

Manufacturers

Featured Products:

Your Title Goes Here

Click Here
Click Here

Browse by Category:

D30 She-Bolts are heavy-duty, reusable form ties for medium and heavy concrete construction.

Data Sheet:

Product Description

Application:
She-Bolts are used in conjunction with D1 or D18 Inside Rods to form tie in a wide range of formwork thickness.

Features:

  • The D30 She-Bolt has a coil thread and is available in 3/4″ through 1-5/8″ diameters in 1/8″ increments.
  • SWL provides a factor of safety of approximately 2 to 1.
  • She-Bolts are meant to be reused, but they do wear so they must be continually inspected. When wear or damage is noted, they must be replaced.
  • A water-proof grease should be applied to the embedded portion of the she-bolt to facilitate removal.
  • Standard sizes are listed in the chart. Sizes other than standard are available on special order.

 

Manufacturer Info

Dayton Superior

AT DAYTON SUPERIOR, WE ARE BUILDING STRENGTH
From our 17,000 hard-working products to our 1200+ dedicated people, Dayton Superior is all about building strength. As the leading single-source provider of concrete accessories, chemicals, and forming products for the non-residential construction industry, we deliver strong, proven products and build strong relationships built on integrity, responsiveness, and unwavering support.

ACCESSORIES
Meticulous attention to detail is built into every product we sell. Our comprehensive range of accessories for every concrete job is unmatched in the industry.

CHEMICALS
Repair, connect, seal, and protect new and existing concrete with our superior portfolio of concrete chemical solutions.

FORMING
Precision endurance, performance, and strength are engineered into our forming systems, including the globally recognized Symons® by Dayton Superior brand.

Related Products:

ImageName
A-46 Bent Loop Tie DS
A46 Bent Loop ties are manufactured from high strength steel.
C-60 Type 1A Exterior Hanger DS
The C60 45 degree Pre-Steel Hanger Type 1A consists of a 1/2" 90 degree end section and a 1/2" 45 degree end section welded to a single wire strut. The hanger allows installation and adjustment from the top of the formwork and works equally well on steel or precast concrete beams. The 90 degree end supports interior forming while the 45 degree end supports the overhang bracket on the exterior side of the beam.
Aztec® E-Z Chair®
The Aztec® E-Z Chair® - PEZ is used for single mat- rebar or wire mesh, bottom layer double mat rebar or wire mesh, tilt-wall, side-form spacer, on-grade: when used with sand plate.