800.876.4857
[email protected]

Categories

Manufacturers

Featured Products:

Your Title Goes Here

Click Here
Click Here

Browse by Category:

A48 Gang Loop Ties are manufactured from high strength steel.

Data Sheet:

Product Description

Application:
A48 Gang Loop Ties are designed for securing and spacing modular type forms.

Features:

  • Standard units are fabricated with 4-15/16″ ends and 1″ breakback.
  • The longer length allows the tie to be used with gang form bolts and to be broken back before the form has been stripped.
  • Other breakbacks, plastic cones and/or water resistant washers are available on special order.
  • Safe Working Load is 2,250 lbs. for standard or 3,000 lbs. for heavy ties which provides a factor of safety of approximately 2 to 1.

 

Manufacturer Info

Dayton Superior

AT DAYTON SUPERIOR, WE ARE BUILDING STRENGTH
From our 17,000 hard-working products to our 1200+ dedicated people, Dayton Superior is all about building strength. As the leading single-source provider of concrete accessories, chemicals, and forming products for the non-residential construction industry, we deliver strong, proven products and build strong relationships built on integrity, responsiveness, and unwavering support.

ACCESSORIES
Meticulous attention to detail is built into every product we sell. Our comprehensive range of accessories for every concrete job is unmatched in the industry.

CHEMICALS
Repair, connect, seal, and protect new and existing concrete with our superior portfolio of concrete chemical solutions.

FORMING
Precision endurance, performance, and strength are engineered into our forming systems, including the globally recognized Symons® by Dayton Superior brand.

Related Products:

ImageName
Sure Anchor J-51
Epoxy Gel Anchor
C-53 Guard Rail Receptacle DS
The C53 Guard Rail Receptacle is designed to allow the easy installation of an OSHA required guard rail post on the exterior formwork of a bridge deck.
C-60 Type 2 Interior Hanger DS
The Type 2 hanger is similar to the Type 1 hanger, except it is designed to be used where the deck has up to a 1" haunch. 1/8" maximum clearance between the edge of the beam and the 1/2" diameter coil bolts. To avoid decreasing the safe working load of the hanger, full bearing of the end clips is required. Hangers must be equally loaded on both sides to prevent formwork from tipping.