D12 Rod Clamps are made from cast malleable iron.
| Data Sheet: |  |
Application:
D12 Rod Clamp is used effectively on all types of forming requirements, especially suited for battered or curved wall applications.
Features:
- Used with smooth or deformed 1/4″ and 3/8″ pencil rods
- For an additional safety measure, Dayton Superior recommends bending the rod approximately 90 degrees behind the clamp
- Used with D14 Tightening Wrench
Related Products:
| Image | Name |
|---|---|
 | C-24 Type 4AS Exterior Hanger DS C24 Pres-Steel Steel Beam Half Hangers are produced using a single end clip welded to a formed wire strut and are used where conditions prevent the use of regular exterior hangers.
Type S Half Hangers are designed for use on steel beams. The standard Type S Half Hanger uses a wire strut that measure 6" from the center line of the bolt to the end of the strut. |
 | D-24 Weld Angle Bracket DS The D24 Weld Angle Bracket consists of a bent plate, pivot pin, and clip. |
 | Continuous High Chair with Plate The CHC Continuous High Chair is a continuous metal bar support used to maintain the elevation of rebar in reinforced concrete. They consist of a top supporting wire connected by evenly spaced legs welded to two continuous base place. Continuous High Chairs are manufactured in the USA. |