A3 Heavy Snap Tie is manufactured with either hot or cold forged integral heads and is equipped with flats or crimps to prevent turning in the concrete during breakback operations. Coating the tie with wax will aid in breakback operation.
| Data Sheet: |  |
Application:
Used for handset wood wall forming.
Features:
- 3,350 lbs. SWL that adds a safety factor of approximately 2 to 1
- Available in any length from 6″ to 480″
- Available with a plastic cone or metal spreader
- Can be manufactured with a tight-fitting neoprene washer (5/8” O.D.x0.187” I.D.x 1/8” thick) located near the center of the tie to eliminate water seepage along the tie
Related Products:
| Image | Name |
|---|---|
 | C-60 Type 4 Interior Hanger DS The C60 Type 4 Pres-Steel Hanger is a heavy duty hanger designed to be used when there is a fillet next to the beam flange. The hanger is manufactured using two 90° end sections that are electrically resistance welded to a 0.440" diameter wire strut. The end clips accepts 1/2" diameter coil rod and/or bolts which along with the coil nuts and washers support the interior formwork loads. |
 | D-9A Taper Tie With D/R Thread DS D9A Taper Ties are used to connect gang modular forms. |
 | Individual High Chair Dayton Superior's Individual High Chair is used to support upper steel directly or by means of a carrier bar. Available in 2" to 15" heights in bright basic, plastic protected, epoxy-coated, or galvanized wire. |