Featured Products:
The CHC Continuous High Chair is a continuous metal bar support used to maintain the elevation of rebar in reinforced concrete. They consist of a top supporting wire connected by evenly spaced legs welded to two continuous base place. Continuous High Chairs are manufactured in the USA.
| Data Sheet: |  |
Product Description
APPLICATION
Continuous High Chair with Plate is used to support upper slab steel over loose compacted soil base, rock base, sand base, or carton forms during construction.
PRODUCT SPECIFICATION
- 5ft. lengths
- (2) 1″ wide base plates
- Cover height 2″ to 15″ in 1/4″ increments
- Available; Epoxy Coated, Hot Dipped, Galvanized, and Plain finish
FEATURES
- Strong, resistance welded construction
- Manufactured in the USA
Manufacturer Info
Dayton Superior
AT DAYTON SUPERIOR, WE ARE BUILDING STRENGTH
From our 17,000 hard-working products to our 1200+ dedicated people, Dayton Superior is all about building strength. As the leading single-source provider of concrete accessories, chemicals, and forming products for the non-residential construction industry, we deliver strong, proven products and build strong relationships built on integrity, responsiveness, and unwavering support.
ACCESSORIES
Meticulous attention to detail is built into every product we sell. Our comprehensive range of accessories for every concrete job is unmatched in the industry.
CHEMICALS
Repair, connect, seal, and protect new and existing concrete with our superior portfolio of concrete chemical solutions.
FORMING
Precision endurance, performance, and strength are engineered into our forming systems, including the globally recognized Symons® by Dayton Superior brand.
Related Products:
| Image | Name |
|---|---|
 | A-48 Gang Loop Tie DS A48 Gang Loop Ties are manufactured from high strength steel. |
 | C-60 Type 2 Interior Hanger DS The Type 2 hanger is similar to the Type 1 hanger, except it is designed to be used where the deck has up to a 1" haunch. 1/8" maximum clearance between the edge of the beam and the 1/2" diameter coil bolts. To avoid decreasing the safe working load of the hanger, full bearing of the end clips is required. Hangers must be equally loaded on both sides to prevent formwork from tipping. |
 | C-24 Type 4AS Exterior Hanger DS C24 Pres-Steel Steel Beam Half Hangers are produced using a single end clip welded to a formed wire strut and are used where conditions prevent the use of regular exterior hangers.
Type S Half Hangers are designed for use on steel beams. The standard Type S Half Hanger uses a wire strut that measure 6" from the center line of the bolt to the end of the strut. |