The type 9-A Pres-Steel Hanger is fabricated with a 90° interlock type end clip and a 45° end clip, both of which are electric resistance welded to a 0.750″ diameter wire strut. Both end clips are designed to accept 3/4″ diameter coil bolts and /or coil rods using B13H (Heavy Hex) nut.
| Data Sheet: |  |
The type 9-A Pres-Steel Hanger is fabricated with a 90° interlock type end clip and a 45° end clip, both of which are electric resistance welded to a 0.750″ diameter wire strut. Both end clips are designed to accept 3/4″ diameter coil bolts and /or coil rods using B13H (Heavy Hex) nut.
Type 9-A hanger is similar to the 4-A, except it is fabricated from 3/4″ diameter strut wire and heavier end clips designed to accept 3/4″ diameter coil rod.
The Type 9-A hanger is intended for use with the C89L Heavy Duty Bridge Overhang Brackets, which requires the use of a 3/4″ diameter coil bolt.
Related Products:
| Image | Name |
|---|---|
 | G-14 Heavy Duty Screed Holders DS Dayton Superior G14 Heavy Duty Screed Holders consist of a rolled steel plate welded to a length of 1" diameter coil rod. The G14 screed holder is used with a free-fit screed base to support screed pipe of various sizes. |
 | C-60 Type 2 Interior Hanger DS The Type 2 hanger is similar to the Type 1 hanger, except it is designed to be used where the deck has up to a 1" haunch. 1/8" maximum clearance between the edge of the beam and the 1/2" diameter coil bolts. To avoid decreasing the safe working load of the hanger, full bearing of the end clips is required. Hangers must be equally loaded on both sides to prevent formwork from tipping. |
 | B-39 Coil Wing Nut DS B39 Wing Nut is made of ductile iron. |
Review C-60 Type 9A Exterior Hanger DS.