The C61 Combination Exterior Hanger is consists of three individual parts made up of a 90° Interior End Section with an integral interlock, a length of 3/4″ diameter coil rod (cut to flange width) and a Combination Exterior End Section.
| Data Sheet: |  |
Application:
The 3/4″ diameter coil rod and the two End Sections are assembled in the field to make up a complete hanger. The length of the 3/4″ diameter coil rod that connects the two End Sections is equal to the beam’s flange width.
The Combination End Section is used with a 1/2″ diameter coil rod/bolt that can be used at any angle from 5° to 45°. In addition, this End Section is also designed to accept 1/2″ diameter coil rod/bolt installed at 90° to the top of the flange.
Two of the External Hanger’s 90° End Sections and a length of 3/4″ diameter coil rod may be used to field assembly a 90° Interior Hanger.
Related Products:
| Image | Name |
|---|---|
 | Sure Anchor J-51 Epoxy Gel Anchor |
 | G-14 Heavy Duty Screed Holders DS Dayton Superior G14 Heavy Duty Screed Holders consist of a rolled steel plate welded to a length of 1" diameter coil rod. The G14 screed holder is used with a free-fit screed base to support screed pipe of various sizes. |
 | C-24 Type 4AS Exterior Hanger DS C24 Pres-Steel Steel Beam Half Hangers are produced using a single end clip welded to a formed wire strut and are used where conditions prevent the use of regular exterior hangers.
Type S Half Hangers are designed for use on steel beams. The standard Type S Half Hanger uses a wire strut that measure 6" from the center line of the bolt to the end of the strut. |