Featured Products:
The D24 Weld Angle Bracket consists of a bent plate, pivot pin, and clip.
| Data Sheet: |  |
Product Description
The Weld-On Pivot Bracket can be attached to steel construction members, including steel piles, metal beams, and weld plates, by following proper welding techniques. The pivot bar is typically furnished with coil thread, euro thread is available on request. The Weld-On Pivot Bracket allows the tie rod to pivot a total range of 110°, or 55° in either direction to tie with forms. The bracket exceeds the tensile capacity of the pivot bar or threaded tie rod being used when properly installed by a certified welder. To ensure proper engagement the threaded tie rod must pass through the pivot bar a minimum of one diameter of the rod. An easy way to accomplish this is to position the tie rod perpendicular to the piling and thread it through the pivot bar until it comes in contact with the piling.
Manufacturer Info
Dayton Superior
AT DAYTON SUPERIOR, WE ARE BUILDING STRENGTH
From our 17,000 hard-working products to our 1200+ dedicated people, Dayton Superior is all about building strength. As the leading single-source provider of concrete accessories, chemicals, and forming products for the non-residential construction industry, we deliver strong, proven products and build strong relationships built on integrity, responsiveness, and unwavering support.
ACCESSORIES
Meticulous attention to detail is built into every product we sell. Our comprehensive range of accessories for every concrete job is unmatched in the industry.
CHEMICALS
Repair, connect, seal, and protect new and existing concrete with our superior portfolio of concrete chemical solutions.
FORMING
Precision endurance, performance, and strength are engineered into our forming systems, including the globally recognized Symons® by Dayton Superior brand.
Related Products:
| Image | Name |
|---|---|
 | Jahn® Scaffold Jack DS A89 Jahn® Scaffold Jack is manufactured from high strength steel. |
 | C-60 Type 8 Interior Hanger DS The Type 8 Press-Steel hanger is similar to the standard Type 1 except the two end clips are designed to angle the 1/2" diameter bolts at 15° from vertical. It is available in two different versions, a standard version or a heavy version. The standard version uses a 0.375" diameter wire to connect the end clips while the heavy version uses a 0.440" diameter wire. |
 | C-60 Type 4 Interior Hanger DS The C60 Type 4 Pres-Steel Hanger is a heavy duty hanger designed to be used when there is a fillet next to the beam flange. The hanger is manufactured using two 90° end sections that are electrically resistance welded to a 0.440" diameter wire strut. The end clips accepts 1/2" diameter coil rod and/or bolts which along with the coil nuts and washers support the interior formwork loads. |