Conversion kits are available for contractor-owned overhang brackets. The kits consist of the top and bottom vertical leg members, the top and bottom diagonal leg members and associated hardware. Consult with Dayton Superior for compatibility and availability.

The C60 Type 1 Pres-Steel Hanger is used for a zero haunch condition and consists of two 1/2" end sections welded to a single wire strut. The hanger allows installation and adjustment from the top of the formwork and works equally well on steel or precast concrete beams.

The C60 45 degree Pre-Steel Hanger Type 1A consists of a 1/2" 90 degree end section and a 1/2" 45 degree end section welded to a single wire strut. The hanger allows installation and adjustment from the top of the formwork and works equally well on steel or precast concrete beams. The 90 degree end supports interior forming while the 45 degree end supports the overhang bracket on the exterior side of the beam.

The Type 2 hanger is similar to the Type 1 hanger, except it is designed to be used where the deck has up to a 1" haunch. 1/8" maximum clearance between the edge of the beam and the 1/2" diameter coil bolts. To avoid decreasing the safe working load of the hanger, full bearing of the end clips is required. Hangers must be equally loaded on both sides to prevent formwork from tipping.

Designed for a 2-1/2" maximum haunch. Uses a corrugated strap to connect the end clips, which are bent outward to provide stability under load. 1/8" maximum clearance between the edge of the beam and the 1/2" diameter coil bolts.

The C60 Type 4 Pres-Steel Hanger is a heavy duty hanger designed to be used when there is a fillet next to the beam flange. The hanger is manufactured using two 90° end sections that are electrically resistance welded to a 0.440" diameter wire strut. The end clips accepts 1/2" diameter coil rod and/or bolts which along with the coil nuts and washers support the interior formwork loads.

The Type 4-A Pres-Steel Hanger is fabricated with a 90° interlock type end clip and a 45° end clip, both of which are electric resistance welded to a 0.440" diameter wire strut. Both end clips are designed to accept 1/2" diameter coil bolts and/or coil rods and nuts.

The C60 - Type 5 - Pres-Steel Hanger is manufactured with two 1/2" 90° end sections welded to a heavy duty wire strut. The Type 5 hanger is used similarly to the Type 4, but does not have the interlock end section feature. C60 Type 5 hangers with 3/4" 90° end sections are available on special order.

The C60 Type 7 Pres-Steel Hanger is similar to the standard Type 1 hanger but has the capacity to accommodate haunch heights up to 1-1⁄2".

The Type 8 Press-Steel hanger is similar to the standard Type 1 except the two end clips are designed to angle the 1/2" diameter bolts at 15° from vertical. It is available in two different versions, a standard version or a heavy version. The standard version uses a 0.375" diameter wire to connect the end clips while the heavy version uses a 0.440" diameter wire.

The type 9-A Pres-Steel Hanger is fabricated with a 90° interlock type end clip and a 45° end clip, both of which are electric resistance welded to a 0.750" diameter wire strut. Both end clips are designed to accept 3/4" diameter coil bolts and /or coil rods using B13H (Heavy Hex) nut.